Both wings are in the stands. I know the posts are a bit… sparse on the details. Most the details can be seen in the videos, but here’s what it took to get here:

Skins were riveted on. Top ones only. They had to be prepped, which includes dimpling and scarfing some of the overlapped joints. Make sure to put your bend in the overlapping edge before dimpling. I’ve missed this in some less consequential areas.

Riveting can be done by one person for much of the riveting. I can sit on the garage floor and get quite a few of them, and the edges. Other than that, it takes two people. I needed help for about two-to-three hours to get each wing’s skins on.

I also had to install the stall warning system. I won’t go to much into this: watch the video.

Better blogs coming soon to a build website near you…