Author: admin
EP 4.29 Installing Windscreen Part 1
Rudder Installed
The rudder has been mounted! I’m quickly wrapping up work on the back end of the plane. The rudder was fairly uneventful to mount, though I anticipate substantially more work to get it hooked up…
Aileron Trim
Fresh off of the elevator trim, I felt I could tackle the aileron trim. However, when I first took out the trim package, I noticed that I had a package that showed mounting in the wing. I remembered mentioning the position of the trim in the wing versus the center of the cabin to Scott […]
EP 4.28 Fiberglass Canopy Skirt
Trim Tab Wired
The trim tab was wired and installed, with linkage, to create a working trim tab. This was cool to interact with.
EP 4.27 The Planning and Cost of Avionics
Elevators, Vertical Stab
The elevators were mounted and hooked up. This was not without an issue with drilling, in which the holes in the elevator horn came too close to the edge and had to be fill welded shut for another shot at drilling. The vertical stab was also first trial fit, then mounted to the deck of […]
Avionics Rundown
Hello. This post is provided as a supplement to the avionics review video, and houses the files for your own review–which makes me nervous, so a bit about that: The file provided are to demonstrate my approach for wiring only. They are not intended to educate, illustrate, or instruct you on how to wire your […]
Mounting Tail Surfaces – A Start
Well, being done with the canopy for the time being, I need somewhere else to point my efforts, and mounting the tail surfaces here in the garage has been recommended by many a folk. The idea is to follow the instructions as if this were final construction, mounting the horizontal stabilizer, then elevators, hooking up […]